Announcement

Collapse
No announcement yet.

Jon00 FLIRC/Harmony Remote/Windows Shortcut Control of Homeseer 3

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    It looks fine. The devices are just sorted differently. I assume you are not running the FLIRC setup software at the same time?
    Jon

    Comment


      #32
      I did have that open earlier to see if the Flirc was receiving commands, but I closed it and still having the issue. If it looks ok to you then I will just tinker with it and see what I can come up with.

      Comment


        #33
        So sorry for resurrecting this older thread on a maybe bit different topic, but I was looking to use a Delgato StreamDeck to trigger events/actions in HomeSeer. The StreamDeck is connected to my normal workstation by USB, and HS3 is running on another system on the same network. Could this plugin be used in any way for it? Or has anyone seen another way of doing it?

        I guess if I was able to run JSON commands on key-press on the StreamDeck, that would solve the question. But I have never used JSON, so I am not sure how I can build command-line strings that I could then run with key-press on the StreamDeck.

        Any tips would be greatly appreciated.

        Comment


          #34
          Actually, without the need of JSON, the StreamDeck allows sending URL in the background, and that seems to be the easiest way to just send JSON URLs directly. So maybe nothing else is needed.

          Comment


            #35
            Originally posted by TomB View Post
            Actually, without the need of JSON, the StreamDeck allows sending URL in the background, and that seems to be the easiest way to just send JSON URLs directly. So maybe nothing else is needed.
            You can find the JSON documentation here: http://help.homeseer.com/help/ASCII-JSON/static/
            Jon

            Comment


              #36
              Originally posted by TomB View Post
              So sorry for resurrecting this older thread on a maybe bit different topic, but I was looking to use a Delgato StreamDeck to trigger events/actions in HomeSeer. The StreamDeck is connected to my normal workstation by USB, and HS3 is running on another system on the same network. Could this plugin be used in any way for it? Or has anyone seen another way of doing it?

              I guess if I was able to run JSON commands on key-press on the StreamDeck, that would solve the question. But I have never used JSON, so I am not sure how I can build command-line strings that I could then run with key-press on the StreamDeck.

              Any tips would be greatly appreciated.
              I don't think this plugin can be used for Elgato Stream Deck - this plugin receives IR commands using Flirc IR receiver. I think for Elgato you should start a new thread.

              I was actually looking into using Elgato as a controller for HS - by creating a plugin for it - which would be possible because Elgato provide SDK for plugin development. But not sure how useful it would be, especially because it's USB, not WiFi.

              What do you think?

              Comment


                #37
                Originally posted by jon00 View Post

                You can find the JSON documentation here: http://help.homeseer.com/help/ASCII-JSON/static/
                jon00 there seems to be no info on JSON there

                Comment


                  #38
                  Originally posted by alexbk66 View Post

                  jon00 there seems to be no info on JSON there
                  Do you not see a folder both on the left-hand side and below marked 'JSON Control Interface'?

                  Edit: scrub that. I see what you are talking about.

                  https://homeseer.com/support/homeseer/HS3/hs3sdk.pdf (Page 5 onward)
                  Jon

                  Comment

                  Working...
                  X