Jon00, I have the config set to showlastonbattery=1 and there was a power outage the APC log shows on 1/10 (0v), but the HS2 Status screen does not show a LastOnBattery device/status. Should it show? Thanks.
Attached Files
-
All Z-Wave, #101 devices, HomeTroller Series2, HomeSeer2 v.2.5.0.81, & 1x Z-Troller -
Yes, a virtual device should be created if you set ShowLastonBattery=1.
This one is a bit difficult to test. I wrote it for someone else and do not use this script myself.Jon
Comment
-
No prob, I'll just wait until the next power outage and see if it fires off then. Thanks.All Z-Wave, #101 devices, HomeTroller Series2, HomeSeer2 v.2.5.0.81, & 1x Z-TrollerComment
-
Has anyone reworked Jon00 APC PowerChute Script to work in HS3?My home is smarter than your honor roll student.
Comment
Comment