This unmanaged plugin allows you to monitor an Eaton (formerly Powerware) Uninterruptible Power Supply (UPS) which uses their free UPS Companion Software. This is normally supplied with all their current range of SOHO UPS. It is an update on Version 1 which used the dated Personal Solution-PAC Power Management Software and does not work with Windows 10.
Using the supplied software allows it to operate the PC as intended but also allow Homeseer access to the data. It will create virtual devices which will enable you to view and trigger on the following metrics:
» Utility supply status
» Battery Capacity
» Estimated run time
» Output load (%)
» Output load (W)
» Output voltage
» Communications lost
» Change to the event log
In addition, virtual devices are created to display the following:
» Estimated energy consumption
» Event log
» UPS details
The plugin monitors the Eaton UPS companion service every 5 seconds. Triggering within Homeseer is via device value changes.
As always, it is available from my site by clicking on my banner below.
Using the supplied software allows it to operate the PC as intended but also allow Homeseer access to the data. It will create virtual devices which will enable you to view and trigger on the following metrics:
» Utility supply status
» Battery Capacity
» Estimated run time
» Output load (%)
» Output load (W)
» Output voltage
» Communications lost
» Change to the event log
In addition, virtual devices are created to display the following:
» Estimated energy consumption
» Event log
» UPS details
The plugin monitors the Eaton UPS companion service every 5 seconds. Triggering within Homeseer is via device value changes.
As always, it is available from my site by clicking on my banner below.
Comment