Can't Set Ocelot Variables

[Kirby]

Thanks, Jim.
I never noticed those interface radio buttons before. That fixed the problem.

Kirby

[jsteed]

I'm running HS 2.1.46 and 1.13.0.2 of Adiocelot. Setdevicevalue is working here. One thing to check is that you have the interface name toggled over to "Adiocelot" rather than "Applied Digital Ocelot" on the general tab of Adiocelot setup.
jim

[Kirby]

Hi Dick,
I'm confident that the variable is not being changed. When the variable is changed to 1 it causes the ocelot to raise a storm shutter. When it is changed to 2 the storm shutter is lowered. The storm shutters work fine if the variable is changed by sending an X10 command or pressing a toggle button attached to a SECU16.
When the ocelot sees that the variable is changed it sets starts the operation and returns the variable back to 0 so its difficult to trace the variable since it is only set for a short period of time.

Kirby

[RAM]

Well I finally bit the bullet and upgraded to HS 2.0 from HS 1.7. Things seem to be working pretty well except for not being able to update variables on the ocelot from HomeSeer. I used a script under 1.7 that did a hs.SetDeviceValue varName,1 where varName is "\8" or similar. It always worked fine under 1.7 but not under 2.0
I have tried removing and recreating the variables, but it didn't help. I know I'm communicating with the ocelot because my temp and humidity devices in HS are being updated from bobcats connected to the ocelot. I looked at the comm log, but I couldn't see anything that helped.
I am using HS 2.0.2041.0 and ADIOcelot 1.13.0.5

Any help would be much appreciated.

Thanks,
Kirby

Have you checked to see if they are getting updated, but just not showing it on the HS devices screens. I have a helpdesk ticket in right now for that. I can change an ocelot variable from within Homeseer and it doesn't appear to have gotten changed, but if I run the ADIOcelot setup and use CMax to check, the variable in the ocelot did get changed, it's just not being reflected back to Homeseer. You may want to put in a helpdesk ticket also. Maybe that would get the priority bumped up.

[Kirby]

Well I finally bit the bullet and upgraded to HS 2.0 from HS 1.7. Things seem to be working pretty well except for not being able to update variables on the ocelot from HomeSeer. I used a script under 1.7 that did a hs.SetDeviceValue varName,1 where varName is "\8" or similar. It always worked fine under 1.7 but not under 2.0
I have tried removing and recreating the variables, but it didn't help. I know I'm communicating with the ocelot because my temp and humidity devices in HS are being updated from bobcats connected to the ocelot. I looked at the comm log, but I couldn't see anything that helped.
I am using HS 2.0.2041.0 and ADIOcelot 1.13.0.5

Any help would be much appreciated.

Thanks,
Kirby