Announcement

Collapse
No announcement yet.

I need your help on triggering

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Michael McSharry
    replied
    The only difference between what you have and what is last posted is the setting of the .misc property upper bits. If you add devices later then it is easier to use the current version rather than needing to run the script again.

    To upgrade, download the zip file from the top of this subforum. Exit Homeseer. Unzip the file into the Homeseer 2 folder. Start Homeseer.

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Hello Michael,

    It seems like I have 1.14.3 (probably downloaded using the Update tool fro HS).

    I supose it is adviced to upgrade.

    Can you please advice how I should do the upgrade?

    Should I remove all Ocelot related devices and reinstall them?


    Thank you very much,
    Clement

    Leave a comment:


  • Michael McSharry
    replied
    Clement,
    The posted version of ADIOcelot (1.14.4) contains logic to deal with the upper bits of the misc property. What version are you running?

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Thank you very much Jim.

    It worked!!

    Best regards,
    Clement

    Leave a comment:


  • jsteed
    replied
    You should be able to trigger on a status change of a relay (just checked). Take a look at this thread - I think that will take care of the issue of being able to select the trigger.
    jim

    Leave a comment:


  • Guest's Avatar
    Guest replied
    Thank you very much Michael!

    I'll give it a try in that way.

    Best regards,
    Clement

    Leave a comment:


  • Michael McSharry
    replied
    ADIOcelot attempts to synchronize DeviceStatus and DeviceValue for the SECU points. Homeseer generally displays DeviceStatus or DeviceString in its Device Status page.

    If you trigger on DeviceValue=1 it should trigger when HS Device Status page shows ON (Status=2). DeviceValue=0 is equivalent to OFF (Status=3).

    Leave a comment:


  • Guest's Avatar
    Guest started a topic I need your help on triggering

    I need your help on triggering

    Hello,

    I try to set-up an event based (triggered) by the change of a Secu 16 Relay .

    BUT the Secu Relay point is not listed between devices at "Devices Status Change" list.

    It is listed at "Device Value Change" but it seems like the Relay Point is tracked only by Status.

    I made the following test usin a script:

    Code:
    Sub Main()
    dim s
    
    s=hs.DeviceStatus("`9")
    msgbox s
    
    End Sub

    Returned 2 when ON and 3 when OFF


    Code:
    Sub Main()
    dim s
    
    s=hs.DeviceString("`9")
    msgbox s
    
    End Sub

    Returned nothing.


    Can you help please?


    Best regards,
    Clement
Working...
X