I just updated the plug in for the Ocelot. I went into config and clicked on the create devices button. I then went to Status and saw that there were 128 variables created (named ^1 through ^64 and ]1 through ]64). I have my Ocelot connected to 2 RLY8-XA devices). I deleted all the created valiables except for ^1 through ^8 and ]1 through ]8. I then changed each of the remaining valiables to digital output and saved them. When I try to turn one of the variables on and off, I watch the ocelot. The active light never lights up when I click on the On or Off button. I am wondering if HS2 is sending the commands to the Ocelot or not. How can I tell?
Thanks,
Jonathan
Note: I am using this setup to have HS2 be able to control a series of speakers which are located throughout the house. The speakers are wired 1 wire into a speaker selector switch and the other wire into the RLY8-XA. With the circut normally off, no sound signal makes it to the speaker. When the Ocelot instructs the RLY8-XA to "turn on", the circut is complete and the sound signal makes it to the speaker.
Note 2: The Active light on the Ocelot flashes on and off 3 times at regular intervals even though no signals (that I know of) are being sent to the Ocelot.
Thanks,
Jonathan
Note: I am using this setup to have HS2 be able to control a series of speakers which are located throughout the house. The speakers are wired 1 wire into a speaker selector switch and the other wire into the RLY8-XA. With the circut normally off, no sound signal makes it to the speaker. When the Ocelot instructs the RLY8-XA to "turn on", the circut is complete and the sound signal makes it to the speaker.
Note 2: The Active light on the Ocelot flashes on and off 3 times at regular intervals even though no signals (that I know of) are being sent to the Ocelot.
Comment