I have had great success so far especially since the new upgrade.
A few observations:
1/
in the graph for relays I usually have either 0 or 1 as per the state of the relay a the time
HOWEVER the AVG colum shows values anywhere from
5 to 50 or so..is is due to the scaling factor for relays in the database?
If so should the relays not be shown as either 0 or 100 to be consistant?
2/
I sometimes see failures in turning a realy ON or OFF from the device on/off command in HS.
It seems that this happens when a RLYXOFF or ON
is sent to temp05 WHILE temp05 is spitting out the temperature readings..at least that is what I gathered from observing thre data streams on my virtual port monitor.
3/I WOULD REALLY LIKE TO BE AB
LE TO HAVE 2-4 instances of MCStemperature as I might have more than 30 sensors and definetely more than 8 relays...
any hints on wether this is achivable or in the works.
KEEP THE GOOD WORK!
A few observations:
1/
in the graph for relays I usually have either 0 or 1 as per the state of the relay a the time
HOWEVER the AVG colum shows values anywhere from
5 to 50 or so..is is due to the scaling factor for relays in the database?
If so should the relays not be shown as either 0 or 100 to be consistant?
2/
I sometimes see failures in turning a realy ON or OFF from the device on/off command in HS.
It seems that this happens when a RLYXOFF or ON
is sent to temp05 WHILE temp05 is spitting out the temperature readings..at least that is what I gathered from observing thre data streams on my virtual port monitor.
3/I WOULD REALLY LIKE TO BE AB

any hints on wether this is achivable or in the works.
KEEP THE GOOD WORK!
Comment