Announcement

Collapse
No announcement yet.

Build 1997 and MCS Temp

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Build 1997 and MCS Temp

    Michael

    Build 1997 fixed the multiple R1 device codes that I was getting.
    But with the discrete devices Which are DS2406's on the stat page they will not Toggle status off/on, but they do show up in the HS Log as working ok
    any ideas?

    Zap
    -Mike-

    -Home automation powered by the wind and sun-
    Zotac 9300g-Q9400s-4gb ram-Intel 120 SSD-MS XP
    HS 2.5.0.20, BLlan,BLweather,MCSXap,Jon00 graphing,Jon00 Whois,Snevl/Ten WeatherAlerts
    W2c,Ztroller,z-wave+18,Q100D's,Silex 3000gb
    Zoneminder 1.24.2 - Ubuntu 11.04 x64 on top of Xenserve
    Zoneminder 1.24.2 - Ubuntu 11.04 x64 Zotac D525 atom

    #2
    Do the DS2406 actually change state when commanded? The code segment that updates the HS status following commanding the DS2406 is below. Both the status and string are updated if the value is different than what HS thinks it was. If HS updates on command rather than when the plugin tells it to update, then this logic will result in it never being updated by the plugin, but HS still should have the correct status.

    Code:
    320               If latch Then
    330                   If hs.DeviceStatus(device) <> 2 Then
    340                       hs.setdevicestatus device, 2
    350                       hs.SetDeviceLastChange device, Now()
    360                   End If
    370                   hs.setdevicestring device, "ON"
    380               Else
    390                   If hs.DeviceStatus(device) <> 3 Then
    400                       hs.setdevicestatus device, 3
    410                       hs.SetDeviceLastChange device, Now()
    420                   End If
    430                   hs.setdevicestring device, "OFF"
    440               End If

    Comment


      #3
      Michael
      Yes they are changing states I have then turning off/on some relays and the HS log is recording the status off or on and my events are running just fine.
      it is the Icon on the status page that is not changing states just shows the off Icon all the time.

      Zap
      -Mike-

      -Home automation powered by the wind and sun-
      Zotac 9300g-Q9400s-4gb ram-Intel 120 SSD-MS XP
      HS 2.5.0.20, BLlan,BLweather,MCSXap,Jon00 graphing,Jon00 Whois,Snevl/Ten WeatherAlerts
      W2c,Ztroller,z-wave+18,Q100D's,Silex 3000gb
      Zoneminder 1.24.2 - Ubuntu 11.04 x64 on top of Xenserve
      Zoneminder 1.24.2 - Ubuntu 11.04 x64 Zotac D525 atom

      Comment

      Working...
      X