Build 1997 and MCS Temp

[zap]

Michael

Build 1997 fixed the multiple R1 device codes that I was getting.
But with the discrete devices Which are DS2406's on the stat page they will not Toggle status off/on, but they do show up in the HS Log as working ok
any ideas?

Zap

[Michael McSharry]

Do the DS2406 actually change state when commanded? The code segment that updates the HS status following commanding the DS2406 is below. Both the status and string are updated if the value is different than what HS thinks it was. If HS updates on command rather than when the plugin tells it to update, then this logic will result in it never being updated by the plugin, but HS still should have the correct status.

320               If latch Then
330                   If hs.DeviceStatus(device) <> 2 Then
340                       hs.setdevicestatus device, 2
350                       hs.SetDeviceLastChange device, Now()
360                   End If
370                   hs.setdevicestring device, "ON"
380               Else
390                   If hs.DeviceStatus(device) <> 3 Then
400                       hs.setdevicestatus device, 3
410                       hs.SetDeviceLastChange device, Now()
420                   End If
430                   hs.setdevicestring device, "OFF"
440               End If

[zap]

Michael
Yes they are changing states I have then turning off/on some relays and the HS log is recording the status off or on and my events are running just fine.
it is the Icon on the status page that is not changing states just shows the off Icon all the time.

Zap