Temperature control

[zap]

Michale
I have three event set up as temperature controls.

Turn ON q3: Z-Wave Interface LIVING ROOM 1 FANIf q3: Z-Wave Interface LIVING ROOM 1 FAN is OFF AND r3: Temperature Living Room-1 Temp is Above 73, Turn OFF q3: Z-Wave Interface LIVING ROOM 1 FANr3: Temperature Living Room-1 Temp is Below 72

Turn ON q1: Z-Wave Interface LIVING ROOM FAN-2If q1: Z-Wave Interface LIVING ROOM FAN-2 is OFF AND r9: Temperature Living Room -2 TEMP is Above 73, Turn OFF q1: Z-Wave Interface LIVING ROOM FAN-2r9: Temperature Living Room -2 TEMP is Below 72

Turn ON q6: Z-Wave Interface WHOLE HOUSE FANIf q6: Z-Wave Interface WHOLE HOUSE FAN is OFF AND r4: Temperature HALL_TEMP is Above 73, Turn OFF q6: Z-Wave Interface WHOLE HOUSE FANr4: Temperature HALL_TEMP is Below 72

only two of them will show upon the stat page under type control
what am I doing wrong

[Michael McSharry]

I only added one status device per Event. Do you have three events here or do you have 3 control loops within one event?

[zap]

Michale
They are setup as three different events

[zap]

Michael
Maybe you missed my last post, so I'll try again. I have set up now four different events each with is own control loop, Shouldn't I be seeing four different status devices one per Event on the asp page?

[Michael McSharry]

Yes I did and yes you should. I'll try to setup multiple ones per your earlier post and see what I get later this evening.

[zap]

Michael,
Have you had a chance to test this yet.

[Michael McSharry]

Forgot about looking at it. Should be able to after work today.

[Michael McSharry]

Have the events associated with these missing devices ever been triggered? The device is only created upon first use and it is only created fror temperature actions that continue until manually turned off (3rd option in pulldown)

[zap]

Michael,
Thanks,
I had not manualy turned the other two control events off and on, now they are showing up