I'm in the process of testing this plugin with my new 1wire system. I currently have 2 sensors on line reporting temps. When I go to see the trends, there are only the defaults listed in the drop down boxes. Then when I click draw, not happens. I running 1.7.44 on a W2k box. I have read through the doc's, but I may have missed how to setup the graphing. If it's in there, what section?
-
-
Take a look at section 5.1.2 of the manual. You need to define a group of your own and include the desired sensors. -
That was it. That's what I get for reading to fast!!!
Thanks!!Comment
-
I'm having a problem with the graphing. Everything was working fine with my 2 sensors. This weekend, I finally pulled my wire through the house and added another (3rd) sensor to the line. All are reporting fine, but I can't get any graphing options. I have noticed on the edit page, I'm getting a sensor showing up twice. One with a 1wire address and one without. When I try to un-check the 2nd sensor and update, the checks boxes are checked again??? I have even created another trend without any luck??Comment
-
post your mcsTemperature.ini and I'll take a look to see if I can see anything.Comment
-
When I get home today, I will post it.
Thanks, RickComment
-
Here you go.
Thanks, RickComment
-
I see you have R2 mapped to two different sensors on the Analog tab. Both are also mapped to the same database field. Update this setup tab so the sensors are as you expect and try again. If that does not get you there then I will put some data in the devices you use and collect it for graphing to evaluate further.Comment
-
After some playing around I finally got it. I had to go and change the codes to get it to work.
Thanks for the help!!!Comment
Comment