I'm running a 1-wire system and a VWS in conjuntion. For 1-wire I am using mcsTemperature and for my VWS system have been using the VWS Homeseer interface.
However from reading the mcsTemperature manual it looks like it is possible to import the VWS data directly into mcsTemperature variables.
I was looking at seting this up but realised I may be embarking on reinventing a wheel that may already be running out there.
I wanted to reach out to all of you and hear if anyone else had already achieved this and whether you could share any secrets/pitfalls etc?
However from reading the mcsTemperature manual it looks like it is possible to import the VWS data directly into mcsTemperature variables.
I was looking at seting this up but realised I may be embarking on reinventing a wheel that may already be running out there.
I wanted to reach out to all of you and hear if anyone else had already achieved this and whether you could share any secrets/pitfalls etc?