No announcement yet.

Control System

  • Filter
  • Time
  • Show
Clear All
new posts

    Control System

    I recently set up a mcstemperature event and specified an UL temp of 85 and a LL Temperature of 65. This is controlling a Fan and a powered Vent. The temperature sensor is a bobcat via an ocelot. The temperature reads properly through homeseer, but in the control Device it shows as "8" and the device will not execute even though the temperature is exceeding 100 degrees.

    Control Active Limits [65 to 85] Now 8, Controlled Device Off

    The temperature device I have is $8 which is over 100 degrees

    I switched to another temperature sensor $9 and the control Device Now shows:

    Control Active Limits [65 to 85] Now 9, Controlled Device Off

    Any Ideas?