Announcement

Collapse
No announcement yet.

Single sensor populate 2 Devices

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • jabrans
    replied
    I figured it out. Should have tired a little more before I posted. All I had to do was check the box next to the device name on the status page and select "copy selected devices" in the drop-down box and type in the room name I wanted the device copied to.

    Jabran

    Leave a comment:


  • Michael McSharry
    replied
    This is an HS2 presentation question. I know it has been requested as a feature in the past, but I do not know HS2 enough to know if it was implemented or not. Your question will get a broader audience in the general hs2 forum.

    Leave a comment:


  • jabrans
    started a topic Single sensor populate 2 Devices

    Single sensor populate 2 Devices

    I am using mcsTemp 4.47.34, HS 2.1.102.0, Temp08 1 wire hardware.

    I would like to have my temp sensors show up in two "rooms". I want each sensor to be in the room that it is physically located in and the room name "temperature".

    What is the easiest way to do this?
Working...
X