I have added a Hobby-Boards moisture board to my mcsTemperature network. It found the 1-wire address and assigned it as a Temperature device

This is a copy of the I/O stream where it locates the device and reads it.

20:13:29 | Port=USB3 Address=7400001262289730 Family=DS2760 Moisture=94.75

This is what was written in the log.
1/27/2009 8:13:29 PM Database Item Saving Device Temperature 7400001262289730D

In the Status page is shows it as a temperature devuce with a reading of 23.

Is there a setup or calibration function I have not found?