Announcement

Collapse
No announcement yet.

mcsTemperature V6 - User axis select option

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    mcsTemperature V6 - User axis select option

    Attached is a V6 of mcsTemperature that contains greater user customization of the charts. Out of the box it should function the same as V5 with the axes and scaling automatically done by hueristic logic. It it also intended to be backward compatible/interchangable with V5 group definitions.

    The primary difference seen by the user is the Group page where the axis can be selected on a sensor by sensor basis to be Auto, Left or Right. In addition the min and max values for the two axis can be specified. Any that are left blank will be autogenerated. Any data that falls outside the user-selected range will be blanked.

    Another difference is the display of the discrete values for periods over 6 hours. For these the quantized ON times are shaded to clearly identify these vs. lines that may also be on the same chart.
    Attached Files

    #2
    Any issues on this version?

    Comment


      #3
      2 little issues
      inside opera i see this, and sometimes all selected data cleared if i go to edit
      Attached Files

      Comment


        #4
        Everything ok so far for me using IE8.
        Best regards,
        -Mark-

        If you're not out on the edge, you're taking up too much room!
        Interested in 3D maps? Check out my company site: Solid Terrain Modeling

        Comment

        Working...
        X