Hobby Boards Moisture

[FeMan]

Michael:

What does mcsTemeprature do when it find a DS2760?
This DS2760 is mounted on a Hobby Boards Moisture meter. The mcsdatabase found the 64bit id and labeled it as moisture.

Do you do any processing of the data from the 2760?

The data that is shown in the status for this device went from +92.4 when the leaf wetness sensor attached was dry to -89.9 when I dip the leaf wetness sensor in water.

Thanks

[Michael McSharry]

I configures it to use internal resistor and then transforms the current measurement using
nMoisture = (((1.6 + nCurrent) * 100) - 50). The moisture reading is what is reported after any user-specified calibration is applied.