Announcement

Collapse
No announcement yet.

Device status time after HS cycle.

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Device status time after HS cycle.

    Michael,

    I have been using MCSMovement for several years with great success so first thank you. Something that has bothered me during that time though is that after a cycle of HS both of my devices show invalid times until they are triggered once. In my case the first device currently shows No movement for 395 days. Which appears to go back to 10/13/2005 when I think I installed MCSMovement after upgrading to HS2. The other device always shows the time that HS was cycled so right now it is showing about 2 hours. I searched through the forum, but did not find anything matching this issue. I don't know if I have something setup incorrectly or if it is currently not possible to display the correct time after HS has been cycled.

    Thanks,
    Jeff

  • #2
    Jeff,
    If you are using one of the later HS betas then this may explain what you are seeing.
    http://board.homeseer.com/showthread...ght=DeviceTime
    -Rupp
    sigpic

    Comment

    Working...
    X