XAP 1-Wire

[Pete]

Michael,

Installed a second combo (Temp/Humidity/Solar) sensor on one of the two 9097's. Noticing that I can see both devices both in the 1-Wire viewer and the XAP 1-Wire application. The second one wire device drops off though after a minute or so and I end up only seeing one device. Wondering if this is me or the application?

07 10:27:46 | Port=COM3 Address=18000801CB238A10 Family=DS1920 Temperature=23.625 |
07 10:27:48 | Port=COM3 Address=2D0008013977B510 Family=DS1920 Temperature=23.1875 |
07 10:27:51 | Port=COM3 Address=54000000A9173A26 Family=DS2438 Temperature=73.85 Humidity=69 Voltage= 4.99 2.95 0 106 |
07 10:27:55 | Port=COM3 Address=6B000000E772F326 Family=DS2438 Temperature=76.2125 Humidity=68 Voltage= 4.93 2.87 0 88 |
07 10:28:11 | Port=COM3 Address=18000801CB238A10 Family=DS1920 Temperature=23.625 |
07 10:28:30 | Port=COM3 Address=6B000000E772F326 Family=DS2438 Temperature=75.9875 Humidity=68 Voltage= 4.93 2.88 0 88 |
07 10:28:32 | Port=COM3 Address=18000801CB238A10 Family=DS1920 Temperature=23.625 |

Here is a picture. I was able to read the two devices initially with a shutdown and startup of the XAP 1-Wire application but then I get no more reads. Notice the time differences between the two.

When I entered the polling ms value for the new devices they both are now being updated. They are both working fine now. I see both devices updating accordingly.


Pete

[Michael McSharry]

When I entered the polling ms value for the new devices they both are now being updated. They are both working fine now. I see both devices updating accordingly.

Does this mean you are OK now or you have an issue now?

[Pete]

I am OK. Thank you.