Hello,
I have two DS2406's that I'm trying to configure as digital inputs. I have them configured in xapmcs1wire as "Switch" and they're detected. On the DS2406, I have the PIO connected to a 10K pullup resistor to 12V. So PIO sees 12VDC. I then have a switch from PIO to ground, making PIO 0V, GND. I see no changes in xapmcs1wire. I've tried changing it to "All switches with alarm" and put the polling at 1000ms on each device. Am I missing something obvious? I'm using the newest .NET version of the plugin. Thanks
I have two DS2406's that I'm trying to configure as digital inputs. I have them configured in xapmcs1wire as "Switch" and they're detected. On the DS2406, I have the PIO connected to a 10K pullup resistor to 12V. So PIO sees 12VDC. I then have a switch from PIO to ground, making PIO 0V, GND. I see no changes in xapmcs1wire. I've tried changing it to "All switches with alarm" and put the polling at 1000ms on each device. Am I missing something obvious? I'm using the newest .NET version of the plugin. Thanks
Comment