Announcement

Collapse
No announcement yet.

mcsCharts

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • mcsCharts

    Hello Michael,

    I have one more question for you. mcsChart all my data is in metric but all graphs legend is referenced in imperial. I did change the setting in the GUI setup to show information in metric. How do I correct this. Not a biggie just cosmetics.

    Regards
    Mark

  • #2
    Initialization sequence issue. It has been fixed and posted at the same location as identified in the library.

    Comment


    • #3
      Thanks Michael, the temperature shows fine in metric however the rain still shows in imperial.
      Last edited by marekd1; December 19th, 2014, 11:29 PM.

      Comment


      • #4
        When I set GUI setup to use metric for rain and then show a chart with rain sensor I see the label as mm. Are both of the conditions used for your test?

        Comment


        • #5
          I checked again, all GUI settings were in metric but it appears that graph is now working. Not sure what happened here, but thank you.

          Comment

          Working...
          X