I'm trying to make my 3rd Arduino project but it doesn't want to communicate with HS reliably.
Using a genuine Arduino ethernet board, plugin version 1.0.0.36, Arduino IDE 1.5.6-r2, API board. The project compiles and runs OK, showing the right outputs on the serial interface but doesn't show any response in HS. If I put a line in the {if (IsConnected == true)} section it never runs, which implies that HS isn't connected, but HS says that it is.
The log shows these lines repeatedly
Feb-05 11:39:21 Arduino Plugin Updating Values on Board No: 3 Feb-05 11:39:20 Arduino Plugin Updating pins on Board No: 3 Feb-05 11:39:20 Arduino Plugin Connected to Board No:3 at ip address 192.168.0.112 Port No:8900 Feb-05 11:39:20 Arduino Plugin Board 3 Version API1.0.0.36 and Plugin Version 1.0.0.36 are compatible. Feb-05 11:39:20 Arduino Plugin Connecting Board No:3 at ip address 192.168.0.112 Port No:8900
but my other API board just reports new values in the log.
I'm very reluctant to change to a beta version of the plugin, as that would probably break the 2 boards that are working correctly at the moment!
Using a genuine Arduino ethernet board, plugin version 1.0.0.36, Arduino IDE 1.5.6-r2, API board. The project compiles and runs OK, showing the right outputs on the serial interface but doesn't show any response in HS. If I put a line in the {if (IsConnected == true)} section it never runs, which implies that HS isn't connected, but HS says that it is.
The log shows these lines repeatedly
Feb-05 11:39:21 Arduino Plugin Updating Values on Board No: 3 Feb-05 11:39:20 Arduino Plugin Updating pins on Board No: 3 Feb-05 11:39:20 Arduino Plugin Connected to Board No:3 at ip address 192.168.0.112 Port No:8900 Feb-05 11:39:20 Arduino Plugin Board 3 Version API1.0.0.36 and Plugin Version 1.0.0.36 are compatible. Feb-05 11:39:20 Arduino Plugin Connecting Board No:3 at ip address 192.168.0.112 Port No:8900
but my other API board just reports new values in the log.
I'm very reluctant to change to a beta version of the plugin, as that would probably break the 2 boards that are working correctly at the moment!
Comment