Announcement

Collapse
No announcement yet.

OTA update

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • randy
    replied
    Originally posted by marekd1 View Post
    Do I have to load any special libraries? I am not able to see the device for the OTA upgrade. Not sure what I am missing.
    Per the instructons, you need to download the libraries from the plug-in config page and you need to add the NodeMCU to the IDE. Once a sketch is loaded to the board by USB you will be able to do OTA going forward.

    Leave a comment:


  • marekd1
    replied
    Do I have to load any special libraries? I am not able to see the device for the OTA upgrade. Not sure what I am missing.

    Leave a comment:


  • marekd1
    replied
    Originally posted by rprade View Post
    Yes. The IDE will only find it on the same subnet.
    Thank you. This is my problem then.

    Leave a comment:


  • randy
    replied
    Originally posted by marekd1 View Post
    yes running the latest versions...

    By any chance do NODEMCU must be on the same subnet as the HS3 or the Arduino IDE?
    Yes. The IDE will only find it on the same subnet.

    Leave a comment:


  • marekd1
    replied
    yes running the latest versions...

    By any chance do NODEMCU must be on the same subnet as the HS3 or the Arduino IDE?

    Leave a comment:


  • randy
    replied
    Originally posted by marekd1 View Post
    Thanks for the info. I did do initial install via USB but none of the boards are showing as you described. I am using WeMos flavors of the NODEMCU not sure if this would matter. Any ideas?

    Mark
    I don't know. Are you running the latest beta of the Arduino plug-in?

    Leave a comment:


  • marekd1
    replied
    OTA

    Thanks for the info. I did do initial install via USB but none of the boards are showing as you described. I am using WeMos flavors of the NODEMCU not sure if this would matter. Any ideas?

    By any chance do NODEMCU must be on the same subnet as the HS3?

    Mark

    Leave a comment:


  • randy
    replied
    Originally posted by marekd1 View Post
    Can't seem to find instructions on how to update the API through the OTA.

    Is there a document that lists the required steps?

    Mark.
    Once you have installed an OTA enabled Sketch from the plug-in via USB, the boards will be available through the IDE for updating over the air. The initial sketch upload must be hardwired.

    Click image for larger version

Name:	Capture.PNG
Views:	1
Size:	180.2 KB
ID:	1197483

    Simply open the sketch you wish to upload in the IDE and upload it to the desired board.

    Leave a comment:


  • marekd1
    started a topic OTA update

    OTA update

    Can't seem to find instructions on how to update the API through the OTA.

    Is there a document that lists the required steps?

    Mark.
Working...
X