-
Well, I think I figure out what the problem was. I did send some debug information through the serial port and that must have thrown off the plugin thinking the port didn't open. -
Serial Connection Issues
The plugin does not connect to my board anymore. I have updated the code but I am not sure it's related to that because even before I frequently had problems. I even tried to lower the baud rate, reset the connection (on the config page), disable and re-enable the plugin, restart the computer, etc but nothing helps. Here is the log I am getting:
Arduino Log Messages will display here:
Checking boards config
Auto Connecting Board No:1
Plug-in initialized.
Warning = Board: 1 has a connection ERROR. Retrying.
New Com port Found
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: