No announcement yet.

Serial Connection Issues

  • Filter
  • Time
  • Show
Clear All
new posts

    Serial Connection Issues

    The plugin does not connect to my board anymore. I have updated the code but I am not sure it's related to that because even before I frequently had problems. I even tried to lower the baud rate, reset the connection (on the config page), disable and re-enable the plugin, restart the computer, etc but nothing helps. Here is the log I am getting:

    Arduino Log Messages will display here:
    Checking boards config
    Auto Connecting Board No:1
    Plug-in initialized.
    Warning = Board: 1 has a connection ERROR. Retrying.
    New Com port Found

    Well, I think I figure out what the problem was. I did send some debug information through the serial port and that must have thrown off the plugin thinking the port didn't open.