Greg I have a nodemcu with a simple sketch with 8 led lights attached. has been working well for sometime. However it seems to be degrading over time. Board #8 seems to be reconnecting itself to HS3, I notice because the lights cycle thru and then reset according to what is set in HS3. I can't see where it is losing wifi connection. It looks to be to HS3. It use to be I could reboot HS3 and it would stop the reconnection issue. but that seems to be not working anymore either. I've attached a debug, hopefully I did it right, and you can take a look and see what is happening.
as a test...I set the lights on the board thru hs3 and then disabled the plugin. so far the board has not reset the lights.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.