Hi All,
i have 4 inputs assigned to pins. 3 of these are connected to motion sensors and 1 is spare. they have been working fine for ages but recently they have become very intermittent some times working some times not.
i tested voltage between ground and the pin and have between 4 and 5 volts.
i have bridged out the pin and ground and get 0 volts but no response in homeseer
what would be the next thing i should check?
thanks
i have 4 inputs assigned to pins. 3 of these are connected to motion sensors and 1 is spare. they have been working fine for ages but recently they have become very intermittent some times working some times not.
i tested voltage between ground and the pin and have between 4 and 5 volts.
i have bridged out the pin and ground and get 0 volts but no response in homeseer
what would be the next thing i should check?
thanks
Comment