Announcement

Collapse
No announcement yet.

Replacing Arduino and sheild issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • enigmatheatre
    replied
    Originally posted by langenet View Post
    Thanks… it's been so long since I've played with this I've actually forgotten that step...
    No Problems. You should just replace your board, Upload the sketch and your good to go.

    Greig.

    Leave a comment:


  • langenet
    replied
    Thanks… it's been so long since I've played with this I've actually forgotten that step...

    Leave a comment:


  • enigmatheatre
    replied
    You would need to download the sketch from the plugin page then upload it to the new board like you did for the first one.

    Leave a comment:


  • langenet
    started a topic Replacing Arduino and sheild issue

    Replacing Arduino and sheild issue

    So I cooked via a bad power supply my mega-3 board. After replacing it, the plugin doesn't seem to connect. I replaced the network shield too. I was under the impression you can just replace these things and the plugin will load the same sketch and off you go. Am I wrong to assume this? What do I need to do to make it work again?
Working...
X