I last upgraded the plugin and sketches about 2 years ago.
Just upgraded to current beta plugin and sketches.
PWM was working fine before with fade in and out, but was a relatively low PWM rate.
Now, the lights are flickering every couple of seconds (irregular intervals) up to 100% then 0% quickly before returning to a set level. THe effect is like when a florescent light is flicking on and off. What should I check? Would this be because I've got old devices in Homeseer, do they need to be upgraded?
Also If the Arduino loses network connection for a while, then it returns, the plugin does not auto connect. I have to click connect, and sometimes even that does not work, I have to restart HS3 for connection to restart.
I am using genuine Arduino Uno + genuine Ethernet shield, and also a genuine Arduino Ethernet. Auto connect is ticked on board setup.
Is this expected behaviour?
Cheers
Just upgraded to current beta plugin and sketches.
PWM was working fine before with fade in and out, but was a relatively low PWM rate.
Now, the lights are flickering every couple of seconds (irregular intervals) up to 100% then 0% quickly before returning to a set level. THe effect is like when a florescent light is flicking on and off. What should I check? Would this be because I've got old devices in Homeseer, do they need to be upgraded?
Also If the Arduino loses network connection for a while, then it returns, the plugin does not auto connect. I have to click connect, and sometimes even that does not work, I have to restart HS3 for connection to restart.
I am using genuine Arduino Uno + genuine Ethernet shield, and also a genuine Arduino Ethernet. Auto connect is ticked on board setup.
Is this expected behaviour?
Cheers
Comment