New to Arduino, I have an UNO connected by USB. It's on com port 6 and has the latest driver, device status: "This device is working properly".
- Using Arduino 1.6.8
- Tried the blink program and it worked.
- I can upload the HomeseerBord1.ino to the board without error.
- I'm getting a "Warning = Com Port No:6 is not open" message.
- The board will say it's connected if I uncheck and check the "Auto Connect" checkbox. but I have no communication coming from the board and HS reads 0% on analog pin 0 even though there is 5v applied, digital pin 2 shows closed.
- I've tried every remedy I could find to resolve the com port closed error but nothing has made a difference.
- Tried uninstalling the com port and reinstalling it several times.
- Baud set to 9600
Comment