This is a great plugin. I have found all kinds of uses for it with NodeMCU modules.
One quick question.
is the 1-wire resolution setting on the config page functional? I have been running a particular device with the resolution at 9 bits but then checked the temperature accuracy and wanted to make that a bit tighter. I changed the resolution to 12 bits. When I down loaded and ran the new board file the temperature seems to be the same. I looked at the .ino file that I just downloaded from the config page and found that the variable TEMPERATURE_PRECISION was still set to 9. I am running V1.0.0.166.
One quick question.
is the 1-wire resolution setting on the config page functional? I have been running a particular device with the resolution at 9 bits but then checked the temperature accuracy and wanted to make that a bit tighter. I changed the resolution to 12 bits. When I down loaded and ran the new board file the temperature seems to be the same. I looked at the .ino file that I just downloaded from the config page and found that the variable TEMPERATURE_PRECISION was still set to 9. I am running V1.0.0.166.