Board automatic connection

[Rinpe]

Hi, I noticed that for example when there is a momentaneous loss power and PC where is installed Homeseer and electronic configuration inclusing arduino boards, switch off and switch on again, there is no an automatic connection with the arduino boards: they result disconnected and the only way to connected again is to the click on a connect button inside the tab status of the arduino board configuration.
Is there a condition to do it automatic?
Thanks

[logbuilder]

You can create an event to test the status and then reset the board

[enigmatheatre]

They should connect if you have Auto connect enabled on the board. Is HS reseting in the power outage or just the boards. Either way it should reconnect. It can take up to 3min in some situations.

[Rinpe]

You can create an event to test the status and then reset the board

Yes, could be an idea thanks

[Rinpe]

They should connect if you have Auto connect enabled on the board. Is HS reseting in the power outage or just the boards. Either way it should reconnect. It can take up to 3min in some situations.

I remember that it was possible to set the auto connection on the board but sorry I can't find it now, why?

[enigmatheatre]

It is located on the board settings popup that you can get by clicking the button highlighted below.