Announcement

Collapse
No announcement yet.

Board automatic connection

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • enigmatheatre
    replied
    It is located on the board settings popup that you can get by clicking the button highlighted below.

    Click image for larger version

Name:	Board Settings.png
Views:	125
Size:	34.1 KB
ID:	1430386

    Leave a comment:


  • Rinpe
    replied
    Originally posted by enigmatheatre View Post
    They should connect if you have Auto connect enabled on the board. Is HS reseting in the power outage or just the boards. Either way it should reconnect. It can take up to 3min in some situations.
    I remember that it was possible to set the auto connection on the board but sorry I can't find it now, why?

    Leave a comment:


  • Rinpe
    replied
    Originally posted by logbuilder View Post
    You can create an event to test the status and then reset the board
    Yes, could be an idea thanks

    Leave a comment:


  • enigmatheatre
    replied
    They should connect if you have Auto connect enabled on the board. Is HS reseting in the power outage or just the boards. Either way it should reconnect. It can take up to 3min in some situations.

    Leave a comment:


  • logbuilder
    replied
    You can create an event to test the status and then reset the board

    Leave a comment:


  • Rinpe
    started a topic Board automatic connection

    Board automatic connection

    Hi, I noticed that for example when there is a momentaneous loss power and PC where is installed Homeseer and electronic configuration inclusing arduino boards, switch off and switch on again, there is no an automatic connection with the arduino boards: they result disconnected and the only way to connected again is to the click on a connect button inside the tab status of the arduino board configuration.
    Is there a condition to do it automatic?
    Thanks
Working...
X