**Appears I was using old documentation, possibly HS2...**
Found the correct one and its now working
http://www.homeseer.com/support/home..._variables.htm
**FIXED**
Hi ALL
I have a 1-wire device id:94 I'm trying to display its value to the LCD.
IN replacement variables I thought I could set the device string to:
$$DV
address) ie: $$DV:94, that just displays same. I gave the device a housecode ie: r40 and then sent $DV:r40 and again it displayed the same. $date prints the date fine....
Any pointers ?
Thanks..Pete
p.s "Technology address is Arduino, Board:4, Rom:37D4DFA201683D5D
Found the correct one and its now working
http://www.homeseer.com/support/home..._variables.htm
**FIXED**
Hi ALL
I have a 1-wire device id:94 I'm trying to display its value to the LCD.
IN replacement variables I thought I could set the device string to:
$$DV

Any pointers ?
Thanks..Pete
p.s "Technology address is Arduino, Board:4, Rom:37D4DFA201683D5D