VB Script Question

[tenholde]

Thanks Tenholde,
However, when I download this onto my windows10 machine and put in the IP address for my HS3 server (HS3 for Linux on a Raspberry Pi running Jessie), it comes up with this error:

Did you extract all four files from the zip file into the same folder, and then run the .exe file from that folder?

tenholde

[mstukel]

I believe the problem is linux. I do not have a linux box to test.

tenholde

If it helps - I can confirm that tenScriptAid works very well when I execute it from my Windows 10 client. I am connecting to the Linux based ZeeS2V2.

tenholde - I cannot thank you enough for creating and sharing this utility. It is an extremely helpful tool.

[tenholde]

Thanks Tenholde,
However, when I download this onto my windows10 machine and put in the IP address for my HS3 server (HS3 for Linux on a Raspberry Pi running Jessie), it comes up with this error:

I believe the problem is linux. I do not have a linux box to test.

tenholde

[dsieg61]

Solved with Events

While not the way I wanted it to go, I have figured out way to do what I wanted using events. Would have been better to create one script that did everything by passing parameters rather that 3 x virtual devices and 6 x events, but I just don't have the time to go figure out how to control devices via raspberry pi plugin.
David

[dsieg61]

tenScriptAid Doesn't work

Thanks Tenholde,
However, when I download this onto my windows10 machine and put in the IP address for my HS3 server (HS3 for Linux on a Raspberry Pi running Jessie), it comes up with this error:

[tenholde]

You may need to issue CAPI commands.

See: tenScriptAid for utility to display device info and generate commands, including CAPI.

tenholde

[dsieg61]

Hello,
I am creating a VB script in which I want to turn output pins on a remote Pi on and off. The Pi plugin is working fine, and normal Homeseer events that change the pin state are working fine.
I am using the "hs.GetDeviceRefBtName", and "hs.DeviceValueEX" to get the device refrence number and current device state for the pin. These seem to work fine. But, when I use "hs.SetDeviceValueByRef" command to turn the remote pin on/off it doesn't actually do it. It does change the state in the "Devices" view on the Homeseer web page, but the pin does not turn on.
I am relatively new to scripting with plugins and I am probably not using the correct commands to do this. Any help would be appreciated.
Regards,
David