Not that I know of.
Here made DIY'd a ZWave ZNet like POE RPi2 with a ZWave dot me GPIO card device which has been fine for the last few years.
Here just made up another SD card to update the firmware. Just shut down the RPi and boot up with ZWave dot me OS.
It really doesn't take that long. Personally I have not done this in a couple of years.
Well just noticed that it's Z-Way now. The updating firmware stuff should be on there too.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Leave a comment: