I know UltraJones isn't monitoring this forum anymore, but hoping another user can chime in
I have two issue:
using a HA7E with only 9 temp sensors connected to the EDS JB6 1-Wire Junction Box (which is a powered hub)
my HS3 is on a UPS & Generator so the system never goes down.
(1) when the power flashes it seems to lock up the 1-wire system; have to power cycle the junction box, and restart the plugin to get readings going again.
any suggestions here?
(2) the plugin keeps added non-existent sensors to HS3. I check the plugin db3 file and I can see them listed and are not enabled.
any way to keep the plugin from adding bogus sensors?
I have two issue:
using a HA7E with only 9 temp sensors connected to the EDS JB6 1-Wire Junction Box (which is a powered hub)
my HS3 is on a UPS & Generator so the system never goes down.
(1) when the power flashes it seems to lock up the 1-wire system; have to power cycle the junction box, and restart the plugin to get readings going again.
any suggestions here?
(2) the plugin keeps added non-existent sensors to HS3. I check the plugin db3 file and I can see them listed and are not enabled.
any way to keep the plugin from adding bogus sensors?