Announcement

Collapse
No announcement yet.

HS3 + TEMP08 + HobbyBoards Humidity sensor = a few problems

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    Yes, I see that Humidity graph is available thru a drop-down menu.

    As of reading electrical current I use a board that Mitch (MidonDesign) sent me back in 2010. He used a spare board and soldered a couple components there and I placed the board inside of the TEMP08.
    The board is connected to the a split-core 3110 sensor that monitors status of my mini-split AC and I have ventilation events based on its reading.

    I had to install an additional 1-wire jack on TEMP08 (seen on the picture with a "Clarity" label on it) and in addition to standard "GND", "DQ" and "+5V" wires I added a "+12V" (for Hobbyboards Humindity sensor) and two wires for current 3110 sensor - total I use 6 wires out of 8 available in an Ethernet cable.
    Attached Files

    Comment


      #17
      Hi, Ultra

      I have been testing my network for some time now and have no problems with Temp and Hum reading/charting .
      Can you please let me know if a graph for Voltage can be added to charts?
      Thank you
      Attached Files

      Comment

      Working...
      X