Announcement

Collapse
No announcement yet.

CAM6.6 Mute

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Blade
    replied
    Not yet - I need to spend some time on this
    It must be coming from the ST2 tuner - I have an ST2 tuner and almost have it hooked up so I will test it out once I get it going

    Leave a comment:


  • Jobee
    replied
    Bump. Any progress on this yet?

    Leave a comment:


  • Jobee
    replied
    I turned on debug
    Stopped the plugin
    Started the plugin
    waited until I saw: BLRussound Info Russound Com Port - HomeSeer (COM2) Open
    Went to my living room keypad (zone 4)
    Pressed the on/off button
    Waited until the music came on and I could hear it in the speakers
    Press the Pause button (mute)
    Waited about 15 seconds
    Press the Pause button (unmute)
    Pressed the on/off button to turn off
    Went back and set the debug off
    Turned the plug in off
    Turned the plug in On

    Not sure I caught everything as the log seems small. I also used the PowerTool and below is a screen capture of the pause key.

    EDIT: I did it again with the output to HS log turned on. Attached it. I see the message where the Pause button was pushed.



    Michael
    Attached Files
    Last edited by Jobee; January 20th, 2017, 09:06 PM.

    Leave a comment:


  • Blade
    replied
    Hmmm I was not aware there was a mute command
    A debug log would be good

    Leave a comment:


  • Jobee
    started a topic CAM6.6 Mute

    CAM6.6 Mute

    Hi Blade,

    I ran into a new problem today. When the source (for me) is #1 which is my ST2 (XM Radio) and you push the pause button on the keypad, it puts the speakers for that room on Mute. This is not reflected anywhere in the plug in and no way to take it off mute except by the keypad.

    Can we get a child device of Mute with an on and off button?

    Do you need a debug log capturing the keypad going on mute and then coming off mute?

    Thanks,

    Michael
Working...
X