Devices show Status Only except for Source

DSteiNeuro

PentaSeer

Posts: 813

Location: Audrey Land (Somewhere near San Diego CA USA)
#1

Devices show Status Only except for Source

October 7, 2011, 10:54 PM

Hello,

I am trying to setup BLRussound with a CAA66.
I was able to set up a controller and populate 6 zones and sources, but when the virtual device are created they only show status except for the zone source, which has the drop down menu to change the source.

I tried deleting asnd recreating the controller but got the same result.

Should't I be able to control zone volume etc?
Attached Files

DSteiNeuro

HS3Pro

MSI Cubi Intel(R) Core(TM) i5-5200U CPU @ 2.20GHz, 2201 Mhz, 2 Core(s), 4 Logical Processor(s) 16GB DDRl RAM

Enabled Plug-Ins
BLRussound, BLSpeech, HSTouch Server, JowiHue, MyQ, Nest, Rain8, Squeezebox, Ultra1Wire3, UltraGCIR3, Vista Alarm, X10,Z-Wave
Tags: None
Uncle Michael

MasterSeer

Posts: 7571

Location: Rochester, NY

HS System: HS3 Pro, Win10
#2

October 16, 2011, 03:14 PM

Most of the control functions are accessible only with scripting functions. For example, I've attached an event that turns one of my zones off. The BLRussound Help file describes the functions with examples.
Attached Files

Mike____________________________________________________________ __________________
HS3 Pro Edition 3.0.0.548, NUC i3

HW: Stargate | NX8e | CAV6.6 | Squeezebox | PCS | WGL 800RF | RFXCOM | Vantage Pro | Green-Eye | Edgeport/8 | Way2Call | Ecobee3 | EtherRain | Ubiquiti
Comment

Announcement