Problem with Global Cache Plugin

[kburns2]

I just recently purchased the Global Cache plugin to use with Homeseer and my GC100. The instructions were quite helpful, but I did have to stop and restart HS after adding the GC100 to HS, and then again after adding the zones. The problem I am now having is that I can configure the signals, but the help menu does not match the config menu for that screen. I can only associate a number to the command, not a name such as Denon Power On as shown in the help files.

What am I doing wrong?

[zgebones]

Not sure if you found the answer already, but I am guessing you were in the "Global Cache Infrared Signals" page and could only see the # in the drop down list.

If you save it to the number the next time you load the page it should show the name.