Hi, I'm having trouble using a sensor plugged into an IR Port on the GC100 as a condition in an event.
I have an input sensor on the GC100 which is triggered depending on whether the device is on or off, this part works when the device is off, the sensor is off.
I created a manual with conditions event with the condition being the device sensor being on or off, and the action sending the power IR code.
No matter what the stat of the sensor being the same as the condition or different the IR signal get's sent, it is ignoring the condition.
From what I have read I'm doing everthing right, can anybody help, or tell me what I'm missing?
I have an input sensor on the GC100 which is triggered depending on whether the device is on or off, this part works when the device is off, the sensor is off.
I created a manual with conditions event with the condition being the device sensor being on or off, and the action sending the power IR code.
No matter what the stat of the sensor being the same as the condition or different the IR signal get's sent, it is ignoring the condition.
From what I have read I'm doing everthing right, can anybody help, or tell me what I'm missing?
Comment