hello
i bought the iTach device so that we could control IR devices from a UPB device ie shut a receiver off from a bed side controller. the iTach was a bit $$ for what it does, but seemed to only device homeseer supports PLUS $30 for the home seer sw
my homeseer controller device is on the LAN side of my network.
the iTach device is connected via wifi , thus is on the wifi side of my network.
The wifi side is NATed to the hardwired LAN side,
I can't find any details stating what IP ports the iTach device use. Thus i can't open the needed ports. The iTach device is on the wifi side and i can access its web browser page
anyone done this type of setup before?
Any tips would be useful
cheers
walter
i bought the iTach device so that we could control IR devices from a UPB device ie shut a receiver off from a bed side controller. the iTach was a bit $$ for what it does, but seemed to only device homeseer supports PLUS $30 for the home seer sw
my homeseer controller device is on the LAN side of my network.
the iTach device is connected via wifi , thus is on the wifi side of my network.
The wifi side is NATed to the hardwired LAN side,
I can't find any details stating what IP ports the iTach device use. Thus i can't open the needed ports. The iTach device is on the wifi side and i can access its web browser page
anyone done this type of setup before?
Any tips would be useful
cheers
walter
Comment