Announcement
Collapse
No announcement yet.
Contact Closure Sensor Push Button
Collapse
X
-
Thank you for the detailed reply. I'll let you know what I decide to do. Still may use an iTach as its not too much more and I know it will work instead of gambling with ZWave.
-
Unfortunately you got the wrong device. You would need
http://store.homeseer.com/store/Glob...-P864C129.aspx
and GC100 and wifi router since GC100 is Ethernet based.
What might work is
http://store.homeseer.com/store/Aeon...P1356C255.aspx
I covered in below thread how to use it as contact closure sensor. Since it is powered by 110V it might have better range/stronger Z-wave signal then battery operated sensors like SM103.
http://board.homeseer.com/showpost.p...41&postcount=5
Leave a comment:
-
Contact Closure Sensor Push Button
Looks like I bought the wrong device but I'm hoping someone on here has an economical workaround for me to try.
I bought a WF2CC iTach device and thought I'd be able to sense whether a switch is in open/closed status. Unfortunately it looks like I can only turn a relay on or off with this device Is this really the case?
What I'm trying to do: By status change trigger an event in Homeseer. The button that will change the status (close circuit) is in my detached garage.
Roadblock: From my garage I can connect to my WiFi network but I'm unable to get my Zwave and Insteon devices to work from there as it's too far from other nodes in my house.Tags: None
Leave a comment: