I was able to get IRTrans up and running on the new hometroller. Even though all the entries for the home theater devices shows up in the infrared devices section the codes do not seem to work. The system works when I relearned a code but seems to have forgotten all the older codes in the move from the old computer to the hometroller. Did I forget to move a database with the codes? Which file is it. It is a lot of work to relearn all the discrete codes that I had before.
If this is your first visit, be sure to check out the FAQ. You must register before you can post.
IMPORTANT: Your first post will be checked for appropriate content. This may take a bit of time.
- If your post is deemed to be spam-free and relevant to the community, it will be approved and you'll be able to post freely here.
- If your post is deemed to be spam, your post will be deleted and your account will be permanently banned.
Comment