Ok, I have been working with James and we have all but one bug worked out. I know on my setup with 11 ESS7 modules the module type was not getting set properly. If your config screen shows ESS7 in the second column under "Type" then you are not affected, if it shows "Unknown" then you have the same bug and the next release will fix that.
There was also an issue with the script command syntax. Here are the commands. If you have the encrypted version (most do) then you will need to change
&hs.RunEx"jvESS_Functions.vb","jvESS_Off","1"
to
&hs.RunEx"jvESS-Functions.vben","jvESS_Off","1"
&hs.RunEx"jvESS_Functions.vb","jvESS_Off","1"
&hs.runex"jvESS_Functions.vb","jvESS_On","1"
&hs.runex"jvESS_Functions.vb","jvESS_AmpA","1"
&hs.runex"jvESS_Functions.vb","jvESS_AmpB","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolDown","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolUp","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolSet","1|6"
You can use the script command in a script (Duh) or in the script statement window under action of an event.
In all of the above commands the "1" is referring to the zone/module number. In the last command "VolSet" the first number is the zone and the second number is the volume level.
I have built several scripts and the switching is fast, example I can switch all 11 zones from Amp A to Amp B in about 1 second
There was also an issue with the script command syntax. Here are the commands. If you have the encrypted version (most do) then you will need to change
&hs.RunEx"jvESS_Functions.vb","jvESS_Off","1"
to
&hs.RunEx"jvESS-Functions.vben","jvESS_Off","1"
&hs.RunEx"jvESS_Functions.vb","jvESS_Off","1"
&hs.runex"jvESS_Functions.vb","jvESS_On","1"
&hs.runex"jvESS_Functions.vb","jvESS_AmpA","1"
&hs.runex"jvESS_Functions.vb","jvESS_AmpB","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolDown","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolUp","1"
&hs.runex"jvESS_Functions.vb","jvESS_VolSet","1|6"
You can use the script command in a script (Duh) or in the script statement window under action of an event.
In all of the above commands the "1" is referring to the zone/module number. In the last command "VolSet" the first number is the zone and the second number is the volume level.
I have built several scripts and the switching is fast, example I can switch all 11 zones from Amp A to Amp B in about 1 second
Comment