Hi everybody,
I have been using the iPad HD app with my SQConnect Gen 2 which worked fine however I have now upgraded to homeseer and have spent many hours putting in all my codes - mainly from the library.
The issue I am having is some of the codes do not work once saved. I get to the end where it says test and I test and the signal works, I hit save. I then go to view my ir codes and click send on the same code/command and it doesn't work?!?!?
I have set the blaster to 5.
Any help would be much appreciated.
Kind Regards
Simon
I have been using the iPad HD app with my SQConnect Gen 2 which worked fine however I have now upgraded to homeseer and have spent many hours putting in all my codes - mainly from the library.
The issue I am having is some of the codes do not work once saved. I get to the end where it says test and I test and the signal works, I hit save. I then go to view my ir codes and click send on the same code/command and it doesn't work?!?!?
I have set the blaster to 5.
Any help would be much appreciated.
Kind Regards
Simon
Comment