Announcement

Collapse
No announcement yet.

UltraGCIR HSPI 1.1.4798.17631- Changes to RELAY devices

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • UltraGCIR HSPI 1.1.4798.17631- Changes to RELAY devices

    Important Note: I made changes to relay devices so they provide feedback when a relay action did not succeed. For GC-100 users, please review any events you may have to activate/inactivate your relays.

    In summary, each HomeSeer relay device now has the following device values:

    -2 = "Inactivate"
    -1 = "Activate"
    0 = "Inactive"
    1 = "Active"

    From the HomeSeer status page or HomeSeer event (device action), you'll use the "Inactivate" or "Activate" to control the relay. If the commands are successful, the relay HomeSeer device is updated with either 0 = "Inactive" or 1 = "Active".

    If a relay stays in either "Inactivate" or "Activate", you'll know Global Cache device never received (or replied) to the command.

    Regards,
    Ultrajones
    Plug-ins: UltraMon, UltraM1G, UltraCID, Ultra1Wire, UltraLog, UltraWeatherBug, UltraPioneerAVR, UltraGCIR
Working...
X