Contacting HomeSeer This Week

HomeSeer is open and operational this week. All orders are being processed and shipped as usual. However, some staff are working from home. If you need to contact HomeSeer for support or customer service, please use our Email or Chat options.
See more
See less

Manual control of relays

  • Filter
  • Time
  • Show
Clear All
new posts

  • Manual control of relays

    I'm a new user to Ultragcir and have a question. The Homeseer GC plug-in allows manual control of a relay on the status page ("On" or "Off"). Ultragcir does not have such a choice (it has "connect" or "disconnect"). Is there a way to control a relay manually with Ultragcir? Thanks.

    Never mind, I figured it out. UltraGCIR apparently sets up the device (e.g., WF2CC, which one can "connect" or "disconnect") and separately sets up each relay of that device (e.g., RELAY 1, which one can "activate" or "inactivate").
    Last edited by Richel; May 29th, 2013, 12:06 PM.