Have installed a couple of Contact Closure Sensors on a GC100. Configured the GC100 for sensor input.
GC100 is recognized by UltraGCir3 plugin and shows device type as Global Cache Sensor, but does not show the change in contact status (always reports it as active). In device configuration shows Status 1=dim and Value 1=active. In status graphics Value 0=Inactive and Value 1=Active.
Thanks for any help
GC100 is recognized by UltraGCir3 plugin and shows device type as Global Cache Sensor, but does not show the change in contact status (always reports it as active). In device configuration shows Status 1=dim and Value 1=active. In status graphics Value 0=Inactive and Value 1=Active.
Thanks for any help
Comment